[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Thruster success



PBT, 

Nice job. 

Looks similar to mine. Those HV sparks look stange and a little dangerous. Personally, I would not run the HV leads up inside of the lateral PVC support pipes. I ran mine to the upper and lower bearing housings. I ran the the upper wire down the inside of the horizontal pipe from a hole drilled in the elbow. I believe you'll get more thrust and speed. 

I never used regulated HVDC currrent, but always HVAC. You may want to power it with a NST. Use a cap and maybe a couple of MWO diodes. I suspect you'll obtain even more performance. BTW, did you detect any ions or wind exiting the ends of the thrusters? 

Stork 



----- Original Message ----- 
From: mrapol@xxxxxxxxxxxx 
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx> 
Sent: Friday, February 11, 2011 12:57:52 PM 
Subject: Re: [TCML] Thruster success 

Video of the thrusters at: 

http://www.youtube.com/watch?v=LrF_8O8kPCU 

PBT 

_______________________________________________ 
Tesla mailing list 
Tesla@xxxxxxxxxx 
http://www.pupman.com/mailman/listinfo/tesla 
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla