RE: [TCML] Vacuum Tube Connection

["Richard Schmuke" <rdj@xxxxxxxxxxxx>]

The connection is the very top of the tube, I run 4 of these tubes in my ham
radio amplifier.

Asking about the preferred hardware and matching stands you mean what we
call sockets. The would be a good idea at a higher frequency like I use them
for , up to 30 MHz but at low frequency use in a Tesla coil they are not
required but would be a convenience.

 

Rich, Kd0zz

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Simon H.
Sent: Sunday, December 11, 2011 7:08 PM
To: tesla@xxxxxxxxxx
Subject: [TCML] Vacuum Tube Connection

 

Hi all,

 

I'm working on a VTTC using a pair of 572B Shuguang and my question is

concerning the Anode connections.  The diagram in the below link shows a

connection on the very top however, on the actual tube it looks to be a

small gold peg to which it is referring.  Is this the actual HV connection

or am i reading something wrong?  I see pins 1 and 4 are for the filament

supply and number 3 is the grid.

 

Since I'm on the subject are there any preferred hardware for making the

connections to the vacuum tube other than the matching stands?  Thanks all

 

Simon

 

 

http://imageshack.us/photo/my-images/39/mailgooglecomap.jpg/

http://imageshack.us/photo/my-images/32/phot9o.png/

http://imageshack.us/photo/my-images/818/photoudh.jpg/

_______________________________________________

Tesla mailing list

Tesla@xxxxxxxxxx

http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla