RE: [TCML] Corian Adhesive

["chuck" <asimov@xxxxxxxxxxxx>]

I have used Corian. It is difficult to cut. It dulls blades like crazy. As
for bonding it, I never had to do it. However, there are videos on YouTube
that detail how to do it.



-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Brandon Hendershot
Sent: Friday, May 28, 2010 3:00 AM
To: Tesla Coil Mailing List
Subject: [TCML] Corian Adhesive


Hello List,
I'm building my primary supports out of a couple of sheets of Corian  
used in counter topping. Being similar to HDPE counter material, I was  
just wondering if anybody here has used this stuff before. Should I  
use some DuPont Corian adhesive(caulking like tube), or should I just  
slather on some two part epoxy? I don't know if the Dupont stuff will  
be so durable in comparison to the epoxy... Again, I'm just wondering  
if anybody has any experience working with this stuff that could give  
me a word of advice before I go messing stuff up.
Thank You,
Brandon
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.819 / Virus Database: 271.1.1/2901 - Release Date: 05/28/10
02:25:00

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla