Re: [TCML] Winding my Secondary

[bartb <bartb@xxxxxxxxxxxxxxxx>]

Miles, is your 4.5" form a little larger than 4.5" diameter? This could 
cause the discrepancy. To counter this, always get more than you think 
you need. But, the 2" won't matter much at all in performance. Your h/d 
is 4.44 with the shorter 20" length and that's perfectly fine. If I were 
you, I would go with it and put new numbers into the program to readjust 
for the 20" length.

Regards,
Bart

Miles Mauldin wrote:
> Hi All,
>
> I came up short on wire for whatever reason; it is what it is. I have a 4.5" coil form with 20" of windings. My plan was for 22" and suspect the spool of wire was not 1500'. Anyway, my question is should I go through the trouble of splicing and continuing to complete my plan or cut the form down 2" and go back JavaTC and redo my plan?  What would you do?
>
> Best Regards,
> Miles
>
> Sent from my iPhone
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
>   
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla