[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[TCML] Terry Filter

To: <tesla@xxxxxxxxxx>
Subject: [TCML] Terry Filter
From: "Dan Casaregola" <ag2z@xxxxxxxxxxx>
Date: Thu, 5 Nov 2009 15:38:06 -0800
Delivered-to: teslaarchive@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
List-archive: <http://www.pupman.com/pipermail/tesla>
List-help: <mailto:tesla-request@pupman.com?subject=help>
List-id: Tesla Coil Mailing List <tesla.pupman.com>
List-post: <mailto:tesla@pupman.com>
List-subscribe: <http://www.pupman.com/mailman/listinfo/tesla>, <mailto:tesla-request@pupman.com?subject=subscribe>
List-unsubscribe: <http://www.pupman.com/mailman/listinfo/tesla>, <mailto:tesla-request@pupman.com?subject=unsubscribe>
Reply-to: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sender: tesla-bounces@xxxxxxxxxx

I'm in the process of building a filter for my 15k/30ma NST, and the drawing I have shows the number of MOVs required for the stated voltage, but it only shows 6 MOV. either side of center tap ground.  I remember reading somewhere that the number of caps should be the same as the number ov MOVs.  Is this correct?  Thank you  Dan
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

Follow-Ups:
- Re: [TCML] Terry Filter
  - From: piranha
- Re: [TCML] Terry Filter
  - From: Paul Brodie

Prev by Date: [TCML] Pig based coil design.
Next by Date: [TCML] Re: Maxwell HV Caps on the bay...
Previous by thread: Re: [TCML] Pig based coil design.
Next by thread: Re: [TCML] Terry Filter
Index(es):
- Date
- Thread