[TCML] For the SISG experienced out there

[bartb <bartb@xxxxxxxxxxxxxxxx>]

Hi All,

I finally made my last purchase of SISG components tonight and enough 
for 6 Mark Dunn boards version 4. I'll be using a different IGBT however 
and went with Terry's 50 ohm resistor for R4 (but upgraded to 3W). I 
only had a few items left so I figured I should dive in and get the last 
three components as the list was quiet and allowed for some free time.
Question: Has anyone ran an NST type transformer (shunts minimized) into 
an SISG setup (or beyond)? I'm planning on basically an 11kV/200mA NST 
of which will be rectified with 15kV/540mA HV diodes (full bridge 
configuration using 4 diodes). I'll be using 6 boards, so there will be 
some decent power to deal with. I'm just curious if anyone's been down 
this road that I'm traveling and could offer any advice on high power 
into the SISG.
Take care,
Bart
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla