[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Series Transformers

To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Subject: Re: [TCML] Series Transformers
From: "DC Cox" <resonance@xxxxxxxxxxxx>
Date: Tue, 17 Jun 2008 15:25:28 -0600
Cc:
Delivered-to: teslaarchive@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
In-reply-to: <22799a1e0806171051q6aec6ea5n696a380cdaee84da@xxxxxxxxxxxxxx>
List-archive: <http://www.pupman.com/pipermail/tesla>
List-help: <mailto:tesla-request@www.pupman.com?subject=help>
List-id: Tesla Coil Mailing List <tesla.www.pupman.com>
List-post: <mailto:tesla@www.pupman.com>
List-subscribe: <http://www.pupman.com/mailman/listinfo/tesla>, <mailto:tesla-request@www.pupman.com?subject=subscribe>
List-unsubscribe: <http://www.pupman.com/mailman/listinfo/tesla>, <mailto:tesla-request@www.pupman.com?subject=unsubscribe>
References: <22799a1e0806171051q6aec6ea5n696a380cdaee84da@xxxxxxxxxxxxxx>
Reply-to: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sender: tesla-bounces@xxxxxxxxxx

use a variac to control the initial voltage, then wire them up and check
output on oscope thru a voltage divider.  Keep variac low until you know
they are not "bucking" each other.

Dr. Resonance

On Tue, Jun 17, 2008 at 11:51 AM, Phillip Slawinski <pslawinski@xxxxxxxxx>
wrote:

> Does anyone know of a way to wire two transformers so that they are
> oppositely phased?
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

References:
- [TCML] Series Transformers
  - From: Phillip Slawinski

Prev by Date: [TCML] 4.1 MFD Cap
Next by Date: Re: [TCML] Chokes and Terry filters
Previous by thread: [TCML] Grounding transformers
Next by thread: Re: [TCML] Series Transformers
Index(es):
- Date
- Thread