Re: Winding Lathe Construction (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

---------- Forwarded message ----------
Date: Wed, 26 Sep 2007 00:02:23 -0400
From: Slurp812 <slurp812@xxxxxxxxx>
To: Tesla list <tesla@xxxxxxxxxx>
Subject: Re: Winding Lathe Construction (fwd)

Actually heres a better pic...

http://www.flickr.com/photos/slurp812/276562790/in/set-72157594444711276/

On 9/26/07, Slurp812 <slurp812@xxxxxxxxx> wrote:
> Heres my setup, well it was anyway the thing was dismantled after I
> was done. I took 3 hours to WIND it, but I took breaks every 20
> minutes or so. So kudos to the guy who wound his by hand in 45, you
> are like a machine er something!!
>
>
> http://www.flickr.com/photos/slurp812/276563309/in/set-72157594444711276/
>
> On 9/21/07, Tesla list <tesla@xxxxxxxxxx> wrote:
> >
> > ---------- Forwarded message ----------
> > Date: Fri, 21 Sep 2007 16:41:52 -0700
> > From: Ed Phillips <evp@xxxxxxxxxxx>
> > To: Tesla list <tesla@xxxxxxxxxx>
> > Subject: Re: Winding Lathe Construction (fwd)
> >
> > Just a tip about placement of your spool of wire:  The picture below shows
> > it normally unwinding by spinning the entire reel of wire.  I prefer to set
> > the spool vertically on the floor and pull it off the reel over the top end
> > of it.  This reduces the likelihood of breaking the wire as it spins up the
> > heavy reel, or having a mess of wire as the heavy reel coasts down, if the
> > reel is mounted horizontally.  The twisting of the wire coming off a
> > vertically placed reel causes no problems at all.
> >
> > --Steve Y."
> >
> >         Standard practice for small wire.  When it gets bigger than say #20 things get more awkward but that size won't break unless you're really careless.
> >
> > Ed
> >
> >
> >
> >
> >
>