Re: Teletype motor (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: List moderator <mod1@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Thu, 17 May 2007 00:39:34 EDT
From: FIFTYGUY@xxxxxxx
To: tesla@xxxxxxxxxx
Subject: Re: Teletype motor (fwd)

 
 
In a message dated 5/16/07 10:37:02 A.M. Eastern Daylight Time,  
tesla@xxxxxxxxxx writes:

>What cap value worked best for you with the phase shift circuit and  the
>Oriental Motor? What value was the motor run cap? I have tried a  ton of

>combinations and you seem to be getting results than I  did.


Alan-
 
    The phase adjusting variac is a Staco Type 291, 3A,  120V, .4kVA unit.
    The phase adjusting cap is 5 uF 370VAC typical  metal can.
    The run cap is a 2.5uF, typical metal can, came  with the motor.
    The motor is marked "X7807-202V    120V  50/60Hz  .35A  2.5uF  LOT 
03225210 Z.P." I'm guessing  "Z.P." might mean "Impedance Protected"? Coulda swore 
it said "1500/1800 RPM"  somewhere, but now that it's mounted I can't seem to 
find that marking.
    Good luck!
 
-Phil LaBudde

Center for the Advanced Study of Ballistic  Improbabilities



************************************** See what's free at http://www.aol.com.