Original poster: "resonance" <resonance@xxxxxxxxxxxx>The sec will not be a problem as it is only 7 ft in dia so it can be transported on a lowboy trailer. It is a continuous winding and sections are not required.
The pri has a pri-sec spacing of 25 inches, so approx dia is 11 ft which is too large for trailer or truck.
Dr. Resonance ----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx> To: <tesla@xxxxxxxxxx> Sent: Monday, January 08, 2007 9:18 PM Subject: RE: an interesting mechanical engineering problem (60ft TC)
Original poster: "Terry Oxandale" <Toxandale@xxxxxxx> Could you explain in more detail the difference between the 7' OD secondary as this compares to the 26' primary with less than 4 turns? Using typical (and your dimensions are NOT typical), one would guess on something in the neighborhood of a 9' ID and about 15' OD? Just curious how the secondary is configured and if you could split it into three or two sections instead of four?