Re: FROM HAL - Starfish Spinner

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "The Krohns" <2halice@xxxxxxx>

Thanks everyone for all of the good suggestions.  I'll keep my eyes open for
a jeweled bearing assembly that will work with my spinner.

Cordially, Hal in Tucson


----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Wednesday, February 28, 2007 6:16 PM
Subject: Re: FROM HAL - Starfish Spinner


> Original poster: <davep@xxxxxxxx>
>
>
>  > Sometimes a good jeweled needle bearing assembly can offer even less
>  > friction.  They are not too expensive and have very low
>  > friction.  They are also made in very small sizes.  Tucson Bearing  may
>  > be able to order them for you.
>
>   a good, metal, 'point in cup' bearing, is quite good, better than
>   ball bearings fro starting friction, and easy 8)>> to had craft.
>   Built a spinner once that way for the relatively low
>   voltage of 15kvdc...
>    best
>     dwp
>
>
>