RE: once again...the correct schematic...

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>

Thanks Turtle,

I'll save this Jewel. So, if I'm not too tired, we can ignore the reactor
@160 and above amps. Are all three winding on the same core? Or separate? My
Miller "infinite adjustment" was a little more simple. Is there a three wire
output on the "s" version?. I have an old one with two.

The main point here is that the primary is 3 times the windings or so and
the secondary has mongo 1/3 windings to produce high current. Shorting the
output above 160 amps bypasses the reactor and allows the most current to
flow to the pig. So... Chips drawing is reversed, Yes?... though the
resistor should stay with the flop.

Thanks for the drawing,
Jim Mora

I am now using a dry pig with a slide reactor. A rocker switch moves a
surplus satellite actuator. Much cleaner! And almost infinite adjustment
again with no handles to crank.



-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Wednesday, November 29, 2006 5:23 PM
To: tesla@xxxxxxxxxx
Subject: RE: once again...the correct schematic...

Original poster: Yurtle Turtle <yurtle_t@xxxxxxxxx>

Here's a Lincoln AC-225-S schematic:

http://www.hot-streamer.com/adam/bigass_coil/welder2.jpg

Adam

--- Tesla list <tesla@xxxxxxxxxx> wrote:

 > Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>
 >
 > PS. The buzz box doesn't look right. The primary
 > (our series load
 > inductance) has more turns than the secondary since
 > it is a step down
 > transformer. Someone please verify this note. I
 > haven't taken my Lincoln
 > apart to see where the taps are.
 >
 > Thanks
 > Jim Mora
 >
 >
 > -----Original Message-----
 > From: Tesla list [mailto:tesla@xxxxxxxxxx]
 > Sent: Wednesday, November 29, 2006 11:09 AM
 > To: tesla@xxxxxxxxxx
 > Subject: once again...the correct schematic...
 >
 > Original poster: "Chip Ford" <chipford@xxxxxxxxxxxx>
 >
 > Here is my 7th. revision to the schematic with
 > the appropriate changes made to the choke
 > setup...Thanks again to everyone..Chip...Ü
 >
 > http://hot-streamer.com/temp/Parallized6.JPG
 >
 >
 >