RE: once again...the correct schematic..., critical part missing, Line filter

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>

Hi Chip,

Assuming you have the balancing act over, you NEED one more assembly, and
that would be the Line Filter. Do a search on Ebay for three phase line
filters. They are usually in the motor stuff which has most of the harmonics
we want to cancel unless you are making a very small diameter coil ( not
recommended with a piggie). Just use two legs of it and it should probably
be in the breaker box (if you get a large one)down stream from the fuses.

On second thought just do a search on "3 phase". You can use two of the legs
in the box as well and they do get BIG. This is ok for a lash up but you
will want to make a control cabinet with a high power Contactor 3 phase too
probably as shown in one of the great schematics sent to you and maybe put
your variac stack in there too.

Getting close!

Jim Mora

If you fail to do this, bad things will happen up stream in your house
wiring.

-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Wednesday, November 29, 2006 11:09 AM
To: tesla@xxxxxxxxxx
Subject: once again...the correct schematic...

Original poster: "Chip Ford" <chipford@xxxxxxxxxxxx>

Here is my 7th. revision to the schematic with
the appropriate changes made to the choke
setup...Thanks again to everyone..Chip...Ü

http://hot-streamer.com/temp/Parallized6.JPG