RE: Offer: rg-58 coax

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: Chip Atkinson <chip@xxxxxxxxxx>

Sure thing, but there are so many other people that make the list what it
is -- a great moderator and over 1100 subscribers.  Many of these
subscribers contributed to the cost of the server that the list runs on.
I couldn't have purchased such a magnificent machine without all the
contributions so many people made.

The quality of the messages and the amount of traffic is really what
makes the list special.  It's really everyone on it that makes it what it
is.

Chip


On Mon, 29 May 2006, Tesla list wrote:

> Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>
>
> Hi Chip,
>
> Thanks for your great forum!!!
>
> I have run miles of that "thin net". Fun when there was a break or
> disconnect somewhere :-{ Leagacy ten base 2 coax thin Ethernet network
> adapters or hubs, etc. can use this (bnc termination) remember 50 ohm
> termination both ends, one side only grounded. Remember the original
> Ethernet mongo cable and vampire taps? I have never seen any that wasn't
> foam internally. 50 ohm signal only. Might be good for pancake primary and
> push pin tap 12,15KV 30ma starter coil!
>
> Jim Mora
> Retired, Net Engineer
>
>
> -----Original Message-----
> From: Tesla list [mailto:tesla@xxxxxxxxxx]
> Sent: Sunday, May 28, 2006 10:31 PM
> To: tesla@xxxxxxxxxx
> Subject: Offer: rg-58 coax
>
> Original poster: Chip Atkinson <chip@xxxxxxxxxx>
>
> Does anyone want some rg58 coax cable?  It's the kind formerly used for
> 10 base 2 ethernet.  I have some and want to get rid of it.
>
> Chip
>
>
>