RE: Offer: rg-58 coax

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>

Hi Chip,

Thanks for your great forum!!!

I have run miles of that "thin net". Fun when there was a break or
disconnect somewhere :-{ Leagacy ten base 2 coax thin Ethernet network
adapters or hubs, etc. can use this (bnc termination) remember 50 ohm
termination both ends, one side only grounded. Remember the original
Ethernet mongo cable and vampire taps? I have never seen any that wasn't
foam internally. 50 ohm signal only. Might be good for pancake primary and
push pin tap 12,15KV 30ma starter coil!

Jim Mora
Retired, Net Engineer


-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Sunday, May 28, 2006 10:31 PM
To: tesla@xxxxxxxxxx
Subject: Offer: rg-58 coax

Original poster: Chip Atkinson <chip@xxxxxxxxxx>

Does anyone want some rg58 coax cable?  It's the kind formerly used for
10 base 2 ethernet.  I have some and want to get rid of it.

Chip