Re: Adjacent-spiral-primary test

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "K. C. Herrick" <kchdlh@xxxxxxx>

Wait!...  Some of my data may be less accurate than they appear.  I 
had cut the outer copper rings in only one place, each side.  That 
was OK when I had the two spirals aligned in the same direction.  But 
when I turned one spiral over, the cuts became displaced.  Then, a 
shorted turn was created, through the screws holding the spirals together.

I'll re-run the tests today or tomorrow.

KCH

Tesla list wrote:
> Original poster: "K. C. Herrick" <kchdlh@xxxxxxx>
>
> I prevail on Terry to post
>
> <http://hot-streamer.com/temp/SPIRALS_IN.JPG>http://hot-streamer.com/temp/SPIRALS_IN.JPG 
>
>
>  and
>
> <http://hot-streamer.com/temp/SPIRALS_OUT.JPG>http://hot-streamer.com/temp/SPIRALS_OUT.JPG 
>
>
> As I've noted, I made the spirals from 2-side p-c stock [snipped]