[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Primary holder questions?

To: tesla@xxxxxxxxxx
Subject: Re: Primary holder questions?
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Tue, 04 Jul 2006 14:55:19 -0600
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
Old-return-path: <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>
Resent-date: Tue, 4 Jul 2006 14:55:25 -0600 (MDT)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <MDr2MC1PA_B.A.koF.9WtqEB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

Original poster: "Dr. Resonance" <resonance@xxxxxxxxxx>

I usually mill them even with the top for a nice snap in. Anotheridea, if the coil is used near any small children in demos, if tomill it 1/8th inch deeper so a plexy topshield can be attached.


Dr. Resonance

I am making a small 4 inch ID primary coil with 1/4 inch coppertubing stuffed into 1/4 inch thick Lexan with 1/4 inch holes and 3/8inch pitch.

Prev by Date: Re: Capacitor
Next by Date: Re: toroid HV terminals for Tesla coils and Van de Graaff generators
Previous by thread: Primary holder questions?
Next by thread: Re: toroid HV terminals for Tesla coils and Van de Graaff generators
Index(es):
- Date
- Thread