[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Bad Pig?



Original poster: "David Rieben" <drieben@xxxxxxxxxxxxxxx>

Curt,

From the data that you've sent, it looks like that you indeed
unfortunately have a bad pig ;^( It appears to have a shorted
or near shorted HV winding as it should NOT be drawing that kind of current with no load across the HV bushing ter-
minals. My pigs have typically drawn only around 1 amp with
a full 240 volt input into the LV bushing terminals if there was no
load across the HV bushing terminals, even with no ballasting.

David Rieben




----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Saturday, January 14, 2006 9:01 AM
Subject: Bad Pig?


Original poster: "C. Sibley" <a37chevy@xxxxxxxxx>
By now I'm sure the group is sick of my trials and
tribulations trying to run my pig.  But as of tonight
I'm pretty sure the pig is dead (or at least
terminal).
Tonight I took a variac and drove voltage into the low
voltage side and read output at the HV bushings.  I
also monitored the input current with a clip on meter.
 See below for data:
Vin    Vout   I
3.1V   163V   6A
6.7V   340V   15A
9.1V   474V   19A
Bottom line, with no load on the HV bushings the pig
draws approximately 20A with only 10V applied.  That
ain't right, is it?
The pig is rated 10KVA, 18200V, 240/120V.  With 240
input that would represent a turn ratio of 75:1.  The
data above is approximately 50:1.  Not sure what that
means but it doesn't seem right...
I'm ready to pich the pig and start a search to find a
new one.  Please advise if I've come to the wrong
conclusion.
Thanks,
Curt.

_