[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Terry Filter On Two NST Grounds?

Original poster: Terry Fritz <vardin@xxxxxxxxxxxxxxxxxxxxxxx>

Hey Miles,

If your are just charging "one" primary cap, then you "should" just need "one" filter. I am not sure how you are wiring the outputs of the NSTs...???

I would "guess" that the inner legs off the NSTs would be at ground too???

Cheers,

        Terry


At 07:12 PM 10/4/2005, you wrote: 
Fellow Coilers,

My NST array is composed to two "layers". The bottom layer has four 7.5KV
30ma NSTs, cheap on e-bay, wired in parallel, with their cases all wired
together. This is NST ground 1. The top layer has four 7.5KV 30ma NSTs,
cheap on e-bay wired in parallel, with their cases all wired together. This
is NST ground 2. The case grounds from layer 1 or from layer 2, and from
mains power are NOT connected together. Do I need two Terry Fritz Filters,
one for the top, and one from the bottom? I really want to just set this one
off and see what it is going to do, but I will risk all the expense and time
of building these very large, very hard to wire, transformer stacks.

Please Advise,

Miles Waldron