[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Safety gap issues



Original poster: "D.C. Cox" <resonance@xxxxxxxxxx>




Were you spark this in single shot pulse mode?

Were you using a well rounded ground electrode with a dia. of at least 8 inches in dia?

If you answer to no to both of these questions the measurement was invalid.

Most people forget to use a well rounded ground electrode of approx 1/3rd the dia. of the main terminal. This, along with single shot mode to prevent excessive ions and spark "growth" invalidate this test procedure.

Also, use either the inductance ratio or capacitance ratio equations to validate your tests. Be sure to take on 70% of this value.

These tests are in almost exact agreement with Terry's planar antenna measrement --- which he loaned me for comparison testing.

Dr. Resonance




Original poster: "Gerry  Reynolds" <gerryreynolds@xxxxxxxxxxxxx>

Hi Dr R.

I dont think even a single shot measurement can be used to estimate the top potential. When my coil was at 1KW with a 6x24 toroid on it, I got a single shot of 18 inches. This would translate to 1.2MV. The initial breakout voltage of the toroid of that size is 500KV. I think the 26.5KV/cm can only be used to estimate potential if the field is uniform and it clearly isn't for these geometries.