[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Newbie Question
- To: tesla@xxxxxxxxxx
- Subject: Newbie Question
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Wed, 23 Nov 2005 12:34:13 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Wed, 23 Nov 2005 12:36:24 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <9kWGBD.A.8q.2SMhDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: otmaskin5@xxxxxxx
Here's my first dumb question...
I just build my 1st coil powered by a 15/60 franceformer. First, I'm
amazed that it actually works. I gotta say I had my doubts during
the long research & construction construction phase. I appreciate
the great info from pupman & from several of you via some of your the
great websites.
I've been running it with just a safety gap and a conversvative
(0.12) primary gap setting until I can build an NST protection
filter. This has produced 26" arcs to ground so far...and that's
about as much as I can go in my basement space before streamers would
start hitting walls & ceilings.
My question is this, as I tinker with the coil & hopefully start
getting longer streamers, could strikes to the walls & ceiling cause
any problems with equipment connected to the house AC wiring? My
concern is the possibility of a streamer finding it's way through the
drywall into the wiring, or maybe more likely, striking an AC outlet
or light fixture & putting a lot of HV & RF directly into the wiring.
My wife's not real big on this whole Tesla thing & frying the house
wiring or our electronic stuff wouldn't help things.
Like I said, this may be a dumb quesion. I'd appreciate any advice. Thanks.
Dennis, Hopkinton MA