[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
expresspcb or ???
- To: tesla@xxxxxxxxxx
- Subject: expresspcb or ???
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Sun, 06 Nov 2005 11:15:28 -0700
- Delivered-to: chip@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Sun, 6 Nov 2005 11:16:18 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <OfLILC.A.LbH.hhkbDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Jim Lux <jimlux@xxxxxxxxxxxxx>
Folks,
I'm designing a controller board as part of a musical tesla coil
project. It essentially has 8-10 relays and an Allegro serial relay
driver chip, along with diodes, other interface stuff, etc.
The board is going wind up being about 20 square inches or so, and
I'm going to need 10-20 of them. I've been happy with ExpressPCB in
the past, but I'm also looking for other possible suppliers.
Ideas?
Jim