Original poster: "Paul B. Brodie" <pbbrodie@xxxxxxxxxxxxx>
Malcolm,
What about non-magnetic stainless steel welding rods in 1/16" diameter? Is
there some other reason not to use stainless steel? They are a lot more
expensive than mild steel but they are also non-magnetic or do they need
to be at least some magnetic? Thanks.
Paul
Think Positive
----- Original Message -----
From: "Tesla list" <<mailto:tesla@xxxxxxxxxx>tesla@xxxxxxxxxx>
To: <<mailto:tesla@xxxxxxxxxx>tesla@xxxxxxxxxx>
Sent: Thursday, May 12, 2005 12:27 PM
Subject: Re: Current Limiting and Impedence
> Original poster: "Gerald Reynolds"
<<mailto:gerryreynolds@xxxxxxxxxxxxx>gerryreynolds@xxxxxxxxxxxxx>
>
> Hi Malcolm,
>
> Where can you get Silicon steel?? Do they make welding rods out of this
> stuff or is there another alloy that would work?? and what diameter rod
> should we be looking for??
>
> Gerry R.
>
>
>>Original poster: "Malcolm Watts"
<<mailto:m.j.watts@xxxxxxxxxxxx>m.j.watts@xxxxxxxxxxxx>
>>
>>Hi Paul,
>> Whatever rods you purchase for the core, they have to have
>>a very small x-sectional area. They should also not retain much if
>>any magnetism after being de-energized (check with a magnet) or they
>>will have large hysteresis losses resulting in lots of heating.
>>Silicon steel such as used in transformer cores is preferred if you
>>can get them.
>>
>>Malcolm
>
>
>
>