Re: primary

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Paul B. Brodie" <pbbrodie@xxxxxxxxxxxxx>

Steven,
Do what Dr. Resonance is always advising people to do while doing initial 
tuning of their coils. Get some 10 AWG or 12AWG insulated wire and make a 
quick and dirty primary coil with this. Just remove a little insulation on 
each turn for places to make your attachments. You can use hot melt glue to 
anchor the wire. It won't look so great but it will get you going in a 
hurry and it will work, especially with a relatively small coil like you 
are building. Good luck. I hope this helps out. Regards.
Paul
Think Positive

----- Original Message -----
From: "Tesla list" <<mailto:tesla@xxxxxxxxxx>tesla@xxxxxxxxxx>
To: <<mailto:tesla@xxxxxxxxxx>tesla@xxxxxxxxxx>
Sent: Sunday, May 08, 2005 2:00 PM
Subject: primary

> Original poster: "Steven Steele" 
<<mailto:sbsteele@xxxxxxxxxxxxx>sbsteele@xxxxxxxxxxxxx>
>
> I need a primary for my TC. For some reason I can't wind my own. I guess
> it's because I am somewhat incompetent. Any way, Does anybody have a primary
> setup that I can borrow for a few days and then send back?
> I need a primary by the 16th and I can't seem to figure out how to keep my
> primary holders up while winding.
> I need a similar primary to the one on Dr. Resonance's plans for the M-20.
> I will pay shipping. I live in Georgia.
> In the meantime I will keep trying.
> Thanks.
>
> Steven Steele
>
>