[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
bipolar coil design
- To: tesla@xxxxxxxxxx
- Subject: bipolar coil design
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Mon, 21 Mar 2005 18:47:17 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Mon, 21 Mar 2005 18:49:19 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <ZB2r-B.A.euG.em3PCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Lee Kohlman <lwkksw@xxxxxxxxx>
I'm new to the list and have been collecting information and parts to build
a tesla coil.
I am planning to build a bipolar coil.
My current specs are looking like this:
Secondary- 20 Awg wound 56" on a 6.25" pvc form, approx 1700 turns
Primary- 6 turns .25" copper tube flat spiral 4.5" id, 8" od at center of
secondary
Hv Supply- 2x 15kV 60mA NST (parallel)
Cap- .03uF 45kV pulse capacitor
Topload- 2x 6" aluminum dryer duct 30" diameter toroid, 1 on each end 4"
from secondary windings.
Secondary frequency- 112.76kHz
Primary- 232.96 kHz
I used javatc to do the calculations. If you want to see the complete
output let me know.
Any ideas?
Thanks,
Lee K.