[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: DIY HV transformer
- To: tesla@xxxxxxxxxx
- Subject: Re: DIY HV transformer
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Thu, 14 Jul 2005 11:24:19 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Thu, 14 Jul 2005 11:26:24 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <tmEbIC.A.HCB._Aq1CB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Steve Conner <steve@xxxxxxxxxxxx>
> I removed the center leg, use one original winding
> as 160 turns primary and
> on the opposite side there sits the HV coil I wound.
Christoph,
This seems to make good sense to me. You could put a
laminated iron shunt into the space where the centre
leg was. So you could have a HV transformer and
ballast choke in one unit. Did you keep the centre leg
when you sawed it off ;)
If you were feeling adventurous you could maybe try
making an adjustable shunt similar to what is used in
arc welders.
Steve Conner