[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Winding technique

Original poster: "Dr. Resonance" <resonance@xxxxxxxxxx>


Wire alignment does not change.  No 360 degree twist.  There is no stress on
the insulation.

Dr. Resonance


>
> It doesn't effect the insulation at all. I've had no insulation problems.
>
> Claude.
> ----- Original Message ----- From: "Tesla list" <tesla@xxxxxxxxxx>
> To: <tesla@xxxxxxxxxx>
> Sent: Monday, January 03, 2005 1:29 AM
> Subject: Re: Winding technique
>
>
> >Original poster: Rob Maas <robm@xxxxxxxxx>
> >
> >At 1/2/2005 05:11 AM, you wrote:
> >>Original poster: "claudio masetto" <claudmas@xxxxxxxxxxxxxxx>
> >>
> >>The clamp is clamping the winding wire and therefore tension can
> >>maintained while winding resulting in a nice tight coil. This can be a
> >>simple peg arrangement with a couple of pieces of felt or it can be made
> >>adjustable so that tension can be adjusted to suit the gauge of wire. It
> >>is mounted on an arm which is in turn mounted on a lead screw which
> >>guides the wire along the length of the coil.
> >>Another thing I have noticed is that a lot of coilers who wind their
> >>coils place the spool with the winding wire horizontal to the secondary
> >>they are winding supported with some sort of bar. This is not necessary.
> >>The spool can be sat upright and the wire will just unwind beautifully.
> >>No problems with an overunning spool.
> >>
> >>Claude.
> >
> >But each unwound turn from the spool will add a 360 degr. twist
> >to the wire, which is not good for the isolation.
> >
> >Rob
> >
> >
> >
> >
>
>
>
>
>