[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: NST Pulse Voltage
- To: tesla@xxxxxxxxxx
- Subject: Re: NST Pulse Voltage
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Sun, 14 Aug 2005 16:45:28 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Sun, 14 Aug 2005 16:47:05 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <phrZuD.A.R5C.mn8_CB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Mddeming@xxxxxxx
In a message dated 8/14/05 2:54:09 P.M. Eastern Daylight Time,
tesla@xxxxxxxxxx writes:
Original poster: "Chris Rutherford" <chris1@xxxxxxxxxxxxxxxxxxx>
Hi Steven,
As I don't have a distribution transformer I'm wondering how to get
the most out of a 10KV NST. When you say 500Vin would that be
continuous or for a couple of seconds?
Thanks
Chris R
Hi Chris,
There are three factors to consider:
1) Saturation (already discussed)
2) Delta_V between layers of winding before the insulation breaks
down and shorts. Power transformers are multi-layered, with not much
more than thin paper between the layers.
3) The E^2/R that the insulation can stand before it melts.
Of these, only #3 is measured in intervals as long as seconds.
Matt D.