Original poster: "Mike Knowlton" <amdx@xxxxxxxxxxx>
> Original poster: "Dr. Resonance" <resonance@xxxxxxxxxx>
> Sec should start 3 inches up on the lower end to insure proper coupling.
Is this assuming a V shaped primary?
> Use two disks inside about 3.5 inches down from the >upper end and 5
inches in from the lower end.
I'd like to find an inexpensive material for these insulative plates (and
end caps). Would varnished particle board be as good as anything?
Mike
> Dr. Resonance
>
>
> >
> > I'm about to start winding a secondary.
> > I have an 8.5" x 42" form.
> >
> > Question 1. Should I start and stop two inches from the ends?
> > (letting the last turn coil in a wide spaced turn to the top)
> >
> > Question 2. Should I put insulating plexiglas plates inside the tube
> > several inches from each end plate?
> > ( how many inches?)
> >
> > Thanks
> > Mike
> >
> >
> >
>
>
>
>