[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: If you had this supply and switch, what would you build?
- To: tesla@xxxxxxxxxx
- Subject: Re: If you had this supply and switch, what would you build?
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Sun, 17 Apr 2005 20:29:55 -0600
- Delivered-to: chip@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Sun, 17 Apr 2005 20:31:17 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <FAalp.A.9sF.nvxYCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Mddeming@xxxxxxx
Hi Dave,
In the back of the RCA Transmitting Tube Manual TT-5, (reprints available
from Antique Radio Supply, Tempe, AZ), there is a schematic for an
induction heater using an 833-A with an output frequency of 450 KHz, so
they can be in the right frequency range. Your results may vary.
Matt D.
In a message dated 4/17/05 10:12:24 P.M. Eastern Daylight Time,
tesla@xxxxxxxxxx writes:
I've often wondered what would happen if you just connected an
appropriately sized primary to the unmodified output of the induction
heater, and then added a Tesla secondary. Wouldn't you have pretty much a
complete VTTC? It seems like that's all you'd need, or am I missing
something? Big induction heaters come up frequently on eBay, and can be
had for little more that shipping costs. Would the typical output
frequency of an induction heater be too low for decent TC performance?