Re: Sync Motors Herbach-dot-com

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Hydrogen18" <hydrogen18-at-bellsouth-dot-net> 

Cant a phase angle adjuster be used to sync them up in the correct position
also?

---Eric
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, November 06, 2004 10:05 PM
Subject: Re: Sync Motors Herbach-dot-com


 > Original poster: "Dr. Resonance" <resonance-at-jvlnet-dot-com>
 >
 >
 >
 >
 > Just remember these are not hysteresis sync type motors.  They sync, but
not
 > always in the same position every time you turn them on.  Sometimes you
have
 > to flick the power switch on and off a few times to get them to sync at
the
 > peak as your RSG electrodes line up.
 >
 > Dr. Resonance
 >
 >  >
 >  > I got my sync motor from Herbach-dot-com today and it is really nice...
 >  > almost as big around as a quart of oil ( for those old enuf to remember
 > the
 >  > quart of oil in the papercan)  and about 3/4 as tall    ( 3 3/4 dia X 3
 > 1/2
 >  > tall not counting shaft)
 >  >
 >  > runs a dead solid 1800 rpm    for an amazing 8.00$
 >  >
 >  > makes a wonderful Sync Gap for NST application in the helicopter or
prop
 >  > style rotor.
 >  >
 >  > after I get the additional parts produced ( mount rotor hub etc) I will
 > try
 >  > to get a few pix up ...   along with the strobe stuff too...  sorry I
 >  > lagged an that part   been busy...
 >  >
 >  > Scot D
 >  >
 >  >
 >  >
 >  >
 >