[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Coil Form needed

To: tesla-at-pupman-dot-com
Subject: Re: Coil Form needed
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 12 May 2004 21:54:13 -0600
Resent-Date: Wed, 12 May 2004 21:58:08 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <gqC_gD.A.hNC.KJvoAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Gerry Reynolds" <gerryreynolds-at-earthlink-dot-net> 

Well,  at 120BPS, that will be 12450 watts of processed power :-)) Peak
current in the caps could be an issue if the number of primary turns is
forced too small.

Gerry R

 > Original poster: "Paul Marshall" <klugmann-at-hotmail-dot-com>
 >
 > I am looking for a coil form 12" or greater diameter. The length should be
 > about 4 times the diameter. Also I am planning on using a 40kV .5uF
 > capacitor for the tank circuit. I have a 25kVA pig to drive it. Has anyone
 > on the list ever used that much capacitance in their tank circuit ?
 >
 >
 >
 > Paul S. Marshall
 >
 >

Prev by Date: Re: Humongous SSTC (was SSTC hits 66" )
Next by Date: Re: Slide-choke construction
Prev by thread: Re: Coil Form needed
Next by thread: Re: Coil Form needed
Index(es):
- Date
- Thread