Re: Pig setup help.

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Bart Anderson <classi6-at-classictesla-dot-com> 

Hi Steve,

Tesla list wrote:

>Original poster: "steve" <steve_vance-at-cablelynx-dot-com>
>I have a question for the list. I have a 10 kva pig I'm running
>at 5 kva to power my coil my 6.5 inch coil. I was reading the archives
>and came across a post about running one of the hv bushings and
>the can to earth ground. Can't find enough information to convince me
>that I fully understand how to do this safely. Someone correct me if I'm wrong
>on this.... I run one of the hv leads to the can, ground the can to earth, run
>the other hv lead to one side of the tank circuit, and the other side of 
>the tank
>goes to the rf ground? Or does it need it's own ground rod?
>
>Thanks for any help.
>
>Steve Vance

You've got it right. The case should be tied to "mains" ground. Then, 240 
to the 2 low voltage bushings.

To bring the inner primary at the same potential (RF ground) as the bottom 
of the secondary, tie one side of the hv terminal to RF ground and the 
other end to the tank. The hv terminal to RF ground does not need it's own 
ground. RF ground is where the connection is.

Take care,
Bart