RE: MMC bleed resistors

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: John <fireba8104-at-yahoo-dot-com> 

My first MMC used Radio Shack 3KV caps and some of the results can be seen 
in the below link.
  <http://www.geocities-dot-com/fireba8104/Temppicture/capdamage.jpg>http://www.geocities-dot-com/fireba8104/Temppicture/capdamage.jpg
Cheers,
John

Tesla list <tesla-at-pupman-dot-com> wrote:
Original poster: "Tristan Steele"

Randy,

These resistors that you have thousands of, are they any different to a
normal 1/2 watt resistor? I have found a relatively cheap source of
'normal' 1/2 watt resistors, but were wondering if they were suitable for
high voltage application. I am about to build a tesla coil, and am trying
to assemble a list of part suppliers in AUS. If anybody has any
recommendations, it would be greatly appreciated.

Secondly, Is it possible to make a MMC using LOTS of Ceramic Capacitors (ie
4700pF 3kV)?

Many Thanks
Tristan


PS - Check my plasma globe photo's -at-
http://www.ph4tboys.endoftheinternet-dot-org/PlasmaG


-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com]
Sent: Friday, 12 March 2004 16:05
To: tesla-at-pupman-dot-com
Subject: Re: M! MC bleed resistors

Original poster: Terry Fritz

Hi Randy,

I have a few thousand of those resistors here. Just send me your address
and how many you want.

Cheers,

Terry


At 08:49 PM 3/11/2004, you wrote:
 >I need to put bleed resistors on my MMC. I went looking for 10M
 >resistors, and S#!t!! There is a big selection and price range for ½ watt
 >10M resistors. Is there a particular type I want? Most have a voltage
 >rating less than I expect to apply to it. As long as I don’t get an arc
 >over the top…. Isn’t a 10M resistor a 10M resistor?
 >
 >Randy