Re: Self-Resonant Driver Boards (DRSSTC, ISSTC, etc...) Bulk Purchase ? ? ? ? Anyone ? ? ?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Mitchell" <Electrontube-at-sbcglobal-dot-net> 

I should ask if he still has one of them,  I still remember there was some
kind of drill error on the board, either misalignment or wrong size...  I
wonder if the "bare bones" series gets the same quality control as the nicer
masked/silkscreened versions ;-)

Regards - Jim Mitchell
----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, June 20, 2004 10:09 PM
Subject: Re: Self-Resonant Driver Boards (DRSSTC, ISSTC, etc...) Bulk
Purchase ? ? ? ? Anyone ? ? ?


 > Original poster: Terry Fritz <teslalist-at-twfpowerelectronics-dot-com>
 >
 > Hmmmm,
 >
 > I think ExpressPCB uses the latest and greatest CNC board drilling
machines
 > with full laser DRO feedback ;-))  Like 0.0001 inch resolution on a really
 > bad day...  The machines self check as they run...  The chance of error is
 > darn near zero there ;-))
 >
 > If the holes did not measure right, I would through the ruler I was using
 > away :o)))
 >
 > Cheers,
 >
 >          Terry
 >
 >
 > At 07:25 PM 6/20/2004, you wrote:
 > >*I* didn't order the boards from EPB,  my friend did, and for simplicity
I
 > >just said "I had a problem"  Some of the holes weren't lined up properly
 > >IIRC.  The boards I've had made from Gold Phoenix have been perfect each
 > >time.  The problem might have just been a one time mistake,  or user
error
 > >(on either part),  but with things like PCBs which can cost quite a bit,
I'd
 > >rather not take chances.
 > >If their record is as good as you say, I'll take your word for it, but
 > >better safe then sorry ;)
 > >
 > >Regards - Jim Mitchell
 > >----- Original Message -----
 > >From: "Tesla list" <tesla-at-pupman-dot-com>
 > >To: <tesla-at-pupman-dot-com>
 > >Sent: Sunday, June 20, 2004 8:59 PM
 > ......
 >
 >
 >