RE: PlasmaSonic II SSTC Board SALE $25.00 EACH or $45.00 for TWO

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Mccauley, Daniel H" <daniel.h.mccauley-at-lmco-dot-com> 

 >Is it possible to make this thing feedback operational?If so, ill take
one.

Matt

Absolutely.  Some will argue this board is inferior because it doesn't
have that option built in, but in fact
the most important thing on the PlasmaSonic is the full-bridge and
driver section.

Also, this driver can fully utilize the better operation of the
UCC37322/21 MOSFET drivers chip which have
lower output impedance and also supports parallel operation of these
MOSFET drivers as well.

Any type of antenna base feedback or other oscillator can easily be put
on the board with minimal problems.
A simple radio shack prototype board (about 1" x 1") can be bought, the
feedback board installed on this, and
this attached right to the top of the Plasmasonic board.  VERY EASY!

Dan