Re: Flyback Driver PCBs

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Arpit Thomas" <arpit-at-inzo-dot-org> 

Dude, in all probability it won't work. I reccomend using a halogne light 
downlight smps.

*********** REPLY SEPARATOR  ***********

On 17/04/2004 at 5:44 PM Tesla list wrote:

 >Original poster: Brett Miller <brmtesla2-at-yahoo-dot-com>
 >
 >
 >Kreso,
 >
 >Great.  I will try this and post the results.  It may
 >however, be a week or two.  Thanks!
 >
 >I have several flybacks ranging from large to small,
 >and one with a built in rectifier for pulsed dc
 >output.
 >
 >-Brett
 >
 >--- Tesla list <tesla-at-pupman-dot-com> wrote:
 > > Original poster: Kreso Bukvic
 > > <kreso.bukvic-at-kc.htnet.hr>
 > >
 > > I invite anybody to try my setup up. It will bring
 > > HUGE sparks.
 > >
 > > Here are the steps:
 > >
 > > 1. Get yourself a PC SMPS i used AT 200 W
 > > 2. Toke the board out.
 > > 3. Remove ferite cored transformer
 > > 4. Connect flyback  primary to the points where
 > > primary of transformer under
 > > 3 were.
 > > 5. Apply power
 > >
 > > Best Regards
 > >
 > > Kreso Bukvic
 > > ----- Original Message -----
 > > From: "Tesla list" <tesla-at-pupman-dot-com>
 > > To: <tesla-at-pupman-dot-com>
 > > Sent: Thursday, April 15, 2004 4:26 PM
 > > Subject: Re: Flyback Driver PCBs
 > >
 > >
 > >  > Original poster: Brett Miller
 > > <brmtesla2-at-yahoo-dot-com>
 > >  >
 > >  > Jim,
msnip....;-))