RE: Fiberglass Resin and Secondary

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Tyler <blimpie120-at-yahoo-dot-com> 

Hmm, i see. Why would the winds be any different for a NST than say a MOT 
or such? I Guess i used formulas and advice form 
<http://www.deepfriedneon-dot-com/>www.deepfriedneon-dot-com
If i calculate for 1400 to 1600 turns it totally screws up my calculations. 
Thank goodness i havent started building yet.

Tesla list <tesla-at-pupman-dot-com> wrote:
Original poster: "Dwight Harm"

Tyler,
Note that current recommendations for NST TCs is to use 1400-1600 turns on
the secondary.
Dwight.

 > -----Original Message-----
 > From: Tesla list [mailto:tesla-at-pupman-dot-com]
 > Sent: Tuesday, September 30, 2003 5:34 AM

 > Original poster: Tyler
...
 > I have now redesigned my plans tho. 3" diameter 17" tall secondary with 24
 > ga wire, 850 turns. The res frequency will be around 372 kHz, with a
 > .0053uF tank cap. 6" inner diameter primary, .025" pipe, spaced about .57"
 > apart, bout 10 winds. A 13" x 3" or smaller torrid for the top.
 > And a 15kv 30ma NST for power, Still have to figure out the filtering
protection for
 > it though.
...



=========
~Tyler