Re: using ignition coils for marx supply

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Anthony" <ant17-at-optushome-dot-com.au> 

i would just use 40 1n4007 in series

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, 29 November 2003 12:43 PM
Subject: Re: using ignition coils for marx supply


 > Original poster: "Jim Mitchell" <Wrenchead-at-starband-dot-net>
 >
 > You would need a big diode, where would you get one?  Just use a flyback
 > transformer.
 >
 > Regards - Jim Mitchell
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Friday, November 28, 2003 9:10 AM
 > Subject: using ignition coils for marx supply
 >
 >
 >  > Original poster: "Anthony" <ant17-at-optushome-dot-com.au>
 >  >
 >  > hi guys i was wondering if any of you guys has had much luck a using a
 >  > rectified ignition coil as a power supply for a marx did it work ok
thanks
 >  >
 >  >
 >  >
 >
 >