[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: components of a roatry spark Gap??

To: tesla-at-pupman-dot-com
Subject: Re: components of a roatry spark Gap??
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Fri, 30 Aug 2002 21:38:11 -0600
Resent-Date: Fri, 30 Aug 2002 21:38:39 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <UX25HB.A.2-E.qoDc9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <dhmccauley-at-spacecatlighting-dot-com>

Heres the list i needed for mine:

http://www.spacecatlighting-dot-com//teslacoil3.htm


1.  Synchronous Motor 1/20Hp, 1800RPM
2.  Polyethlene for base
3.  PVC for motor support
4.  Stainless steel screws 
5.  Nylon screws (for HV resistant attachments)
6.  Brass stock for stationary electrodes
7.  Brass nuts for electrode holders
8.  2% Thoriated Tungsten for electrodes
9.  Terminal block
10. CE Phenolic for rotor
11.  Lathe to cut disk
12.  Lathe to create rotor hub


Dan

Prev by Date: RE: New 4" coil: R.Hull and CSN, Secondary Varnish
Next by Date: Variac Schematic question.
Prev by thread: components of a roatry spark Gap??
Next by thread: arc length/secondary length and magnifier questions
Index(es):
- Date
- Thread