[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

mdpe tubing for secondary form

To: tesla-at-pupman-dot-com
Subject: mdpe tubing for secondary form
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 23 Oct 2002 20:40:35 -0600
Resent-Date: Wed, 23 Oct 2002 20:43:32 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <2bUJvC.A.37E.T51t9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Justin Wright by way of Terry Fritz <twftesla-at-qwest-dot-net>" <justin-at-tracesofnut-dot-com>

Hello All,

I have found a source of MDPE tubing (thanks to Mark Finnis).  The
tubing they have is 200mm (8") but the walls are 8-9mm thick.

I have heard that the thickness of the tubing will affect the
performance of the coil?  

Is this thickness going to be a problem?


 
Regards

Justin.

Prev by Date: Re: NST Rework?
Next by Date: Early oscillatory circuits
Prev by thread: Re: Stone Stone
Next by thread: Re: mdpe tubing for secondary form
Index(es):
- Date
- Thread