Re: Hvguy-dot-com Feedback SSTC and New Stuff!!!

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jolyon Vater Cox by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jolyon-at-vatercox.freeserve.co.uk>

Ken,
With regard to common base circuit reconfigured slightly to include a 1k
resistor
would this work if Phases 1 & 2 instead of being used to drive the fets
directly were used to drive an amplifier which would drive
the fets say, via a pulse transformer?

                         +ve supply rail
 > >                    |
 > >                    R1
 > >                    |
 > >                    +-------Phase 1
 > >                 c |
 > >                    \
 > >            NPN |---------GND
 > >                e /
 > >    sec         |
 > >    |              |
 > >   +--1K----+
 > >   |               |
 > > c1           e \
 > >   |       PNP |----------GND
 > >   |            c /
 > >   |               |
 > >  +---------------------GND
 > >                   |
 > >                  +----------Phase 2
 > >                   |
 > >                  R2
 > >                   |
 > >                  -ve supply rail





(The circuit I have shown is basically a non-inverting
voltage amplifier. The emitter-base junctions of the NPN
and PNP transistors act in the same way as the
back-to-back diodes in the setup you described -switching
on the respective transistors whenever voltage across
them goes above and below 0.6 volts, positive or negative
of ground)

Jolyon.


----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, November 14, 2002 1:58 AM
Subject: Re: Hvguy-dot-com Feedback SSTC and New Stuff!!!