[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: New Toroid

Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jim-at-jlproduction-dot-com>

Hi there,
The comment-
"tapped in -at- 12 turns"
seems a bit off to me. I have an almost identical coil (2 NST of 9/KV-30
MA each,same od form and height) and I am tapped in 6 turns with one
toroid and 7 with two. It can push AT LEAST 25 inch sparks with no break
point at all.
I would try some re-tuning, closer in and with a light taped to a stick
to see where it is brightest. I think you may be out to the so called
"second" frequency point but are running out of room on the primary.

Stay "tuned"
Jim L

-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com] 
Sent: Tuesday, May 28, 2002 7:31 PM
To: tesla-at-pupman-dot-com
Subject: New Toroid

Original poster: "Shaun R. Phelps by way of Terry Fritz
<twftesla-at-qwest-dot-net>" <shaun-at-visorloop-dot-com>


I've just completed construction of a new toroid for my coil and am
some problems.  Maybe someone can shed a bit of light.

Input: 9KV 60mA
Secondary: 23" * 4.5"
Toroid: 4.5" flexible aluminum duct.  19" outside diameter, wrapped in
aluminum foil.
Cap: 12beer bottle  + 1 wine bottle SWC
Primary: 1/4" copper tube, 1/2" spacing, tapped turn ~12.

Previously I used two 12" salad bowls as the toroid and achieved 12"
When I replace that toroid with the new one, I achieve no sparks.  If I
a breakpoint on the new toroid, I seem to get 4" sparks from that
breakpoint.  I assume that there is simply not enough voltage present to
break sparks from this new toroid and that is my problem.  However, I
read numerous posts specifying that 'you can never have too much
I thought I would be advancing my coil by adding this new toroid and
see better sparks, but I see this is not the case.  I'm wondering if I
should try and increase the input voltage or current to get the sparks I
desire, and if I do so, can I expect better sparks from the new toroid
compared to the salad bowls?  In other words, after increasing the
might I expect bigger sparks using the new toroid or the old?  Any other

Thanks for any advice.