Re: VTTC chokes

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "R. Bergmann by way of Terry Fritz <twftesla-at-qwest-dot-net>" <bergmann_-at-hotmail-dot-com>

I thnik I found some suitable ones a this site:

http://www.mgs4u-dot-com/inductors.htm

I am looking at either the PC-1 or the L-4


thanks
Ryan






>From: "Tesla list" <tesla-at-pupman-dot-com>
>To: tesla-at-pupman-dot-com
>Subject: Re: VTTC chokes
>Date: Sun, 23 Jun 2002 13:02:36 -0600
>
>Original poster: "rheidlebaugh by way of Terry Fritz <twftesla-at-qwest-dot-net>" 
><rheidlebaugh-at-zialink-dot-com>
>
>Ryan: Most people wind or buy coil stock and cut it to length. Power supply
>chokes (iron core) can be wound, but are usualy purchesed. Most RFC chokes
>are small enough to wind on a resistor body and not purchesed. As you did
>not give the size of choke neaded I can't be much help. Small toroid cores
>can be found at 'Radio Shack" if you know what you are in nead of. Wire
>wound resistors serve as RFC if you know the size you nead. I use 1K 100w 
>ww
>resistors as 220 uH Rfc coils.
>   Robert  H
>
> > From: "Tesla list" <tesla-at-pupman-dot-com>
> > Date: Sat, 22 Jun 2002 18:29:40 -0600
> > To: tesla-at-pupman-dot-com
> > Subject: VTTC chokes
> > Resent-From: tesla-at-pupman-dot-com
> > Resent-Date: Sat, 22 Jun 2002 18:31:10 -0600
> >
> > Original poster: "R. Bergmann by way of Terry Fritz 
><twftesla-at-qwest-dot-net>"
> > <bergmann_-at-hotmail-dot-com>
> >
> > I need some choke for my vttc.  I am using two svetlana 572b tubes, a
> > 2100volt 300ma plate transformer, and a 6.3volt 8amp filament 
>transformer.
> > There is a nice choke at rfparts-dot-com(rfc-3), but it is too expensive.  
>Do
> > you know any good places to get chokes?  And any suggestions on the 
>ratings
> > I should use are very appreciated.
> >
> > Thanks,
> > Ryan Bergmann
> >
>
>