[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Size of Rotor in SRSG

To: tesla-at-pupman-dot-com
Subject: Size of Rotor in SRSG
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Tue, 23 Jul 2002 08:22:54 -0600
Resent-Date: Tue, 23 Jul 2002 08:24:22 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <Fs0zlD.A.bXG.BcWP9-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Mccauley, Daniel H by way of Terry Fritz <twftesla-at-qwest-dot-net>" <daniel.h.mccauley-at-lmco-dot-com>



	What characteristics of a SRSG would change by using smaller size
rotor.  Originally i was going to use a 7" dia. rotor disk, but may be
forced to use a 6" dia. rotor disk due to the limitations of my lathe.  

	The angular velocity will remain the same, but what other things
should i worry about.  

	Thanks
	Dan

Prev by Date: RE: For Sale: 2" Diameter Corona Balls
Next by Date: RE: Batch of Synchronous Motors - Nice 1/4" Hub
Prev by thread: Re: Gap Arc Voltage Was: Natural streamer
Next by thread: Re: Size of Rotor in SRSG
Index(es):
- Date
- Thread