1800 rpm synchro motor

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "D.C. Cox by way of Terry Fritz <twftesla-at-qwest-dot-net>" <DR.RESONANCE-at-next-wave-dot-net>

 
Motor length w mtg flange = 5.5 in.
 
Motor dia. = 3.25 in. circular
 
Shaft dia x length = 5/16 in dia x 3/4 in beyond mtg flange   
 
Shaft has flat.  Place TIG electrode directly above this flat to achieve cap
firing at the 60 Hz sinewave peak.
 
1/25 hp continuous duty, runs a 7 in. rotor disk w/ 4 1/8th in. TIG electrodes
at 1800 RPM in sync with 60 Hz line.
 
4 MFD external run cap supplied.
 
We make holder in an "L" shaped aluminum bracket with 6.25 in. height, 4 in.
width, and 4 in. deep (under motor).  We also use two 1.5 x 1.5 in. 45 degree
alum. gussets in each corner to strengthen the mtg.
 
Price is $26.50 per motor.  We still have a few units in stock.  
 
Best regards,
 
Dr. Resonance
 
http://hot-streamer-dot-com/temp/1800RPM-Synchro-Motor.jpg