Re: MMC for 4 pack MOT supply

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "colin.heath4 by way of Terry Fritz <twftesla-at-qwest-dot-net>" <colin.heath4-at-ntlworld-dot-com>

hi allan
            i had the exact smae problem with my mots. how many are you
using?
i was using two but the voltage doubler had failed and there wasnt enough
voltage to jump the gap
remember the voltage might jump the gap stationary as it has time to ionise
the air more when its spinning it has less time to ionise air
i had to close my gap very close
cheers
colin

----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, July 13, 2002 1:17 AM
Subject: Re: MMC for 4 pack MOT supply


> Original poster: "Tim J by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<digital_raven45-at-hotmail-dot-com>
>
>
>
>
> >From: "Tesla list" <tesla-at-pupman-dot-com>
> >To: tesla-at-pupman-dot-com
> >Subject: Re: MMC for 4 pack MOT supply
> >Date: Fri, 12 Jul 2002 08:07:33 -0600
> >
> >Original poster: "Allanh by way of Terry Fritz <twftesla-at-qwest-dot-net>"
> ><allanh-at-starband-dot-net>
> >
> >I plan to use two banks of 10 caps each which will give me 66 nf at 20KV.
> >I've been using a fixed multi gap but
> >when I tried a sync motor at 1800 RPM, two fixed electrodes and two
> >rotating, I got nothing. This same RSG worked with an NST, but dosen't
work
> >with MOT's. I've tried .01 gaps but it only fires when the motor is
> >switched
> >off and the rotor slows way down.  Any ideas.
> >
> >allan
>
> -----------------------------------------------------------------------
>
> You need more electrodes and a faster RPM motor to make a more of a
curcuit
> connection! I'm fairly sure that this will solve your problem.
> I am using 10 electodes rotating/ 10 fixed with the 10,000 RPM angle
grinder
> powered RSG. The more BPS you get the more charge per second one gets.
>
> _
>
>