Re: Secondary Winding Jigs

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jim Lux by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jimlux-at-earthlink-dot-net>

Dave has a good point here...   A standard barbecue rotisserie, while a bit
slow for the winding, does have a nice motor, a square shaft 3 feet long,
etc.


----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, December 15, 2002 1:06 PM
Subject: RE: Secondary Winding Jigs


 > Original poster: "Dave Kyle by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<dave-at-kyleusa-dot-com>
 >
 > I absolutely agree. I built the following jig
 > http://home.austin.rr-dot-com/dkyle/images/Tesla2%20026%20(Medium).jpg and
 > it has been a godsend compared to my earlier hand winding experiences.
 > It is hand powered for the winding process. I get my son to turn the
 > crank and a 6 x 36 coil can be done in about an hour. I added a
 > rotisserie motor to turn it for apply coatings to the coil, eliminating
 > drips.
 >
 > Dave
 >
 > =========================================
 > Dave Kyle
 > Austin, TX USA
 > Email: dave-at-kyleusa-dot-com
 >
 >
 > -----Original Message-----
 > From: Tesla list [mailto:tesla-at-pupman-dot-com]
 > Sent: Sunday, December 15, 2002 2:05 PM
 > To: tesla-at-pupman-dot-com
 > Subject: Re: Secondary Winding Jigs
 >
 > Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
 > <dhmccauley-at-spacecatlighting-dot-com>
 >
 >
 >   > Hello all,
 >   >
 >   > The one pointer that I have for you is this: BUILD SOMETHING TO WIND
 > YOUR
 >   > COIL WITH!
 >
 >