[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: OLTC update - winding the secondary
Original poster: "Lau, Gary by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Gary.Lau-at-hp-dot-com>
I used a very similar jig, also with VSR drill and Variac. The problem I
had was finding a support "bearing" for the threaded rod to pass through
that doesn't engage the threads.
Regards, Gary Lau
MA, USA
-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com]
Sent: Friday, August 23, 2002 1:53 AM
To: tesla-at-pupman-dot-com
Subject: OLTC update - winding the secondary
Original poster: "Terry Fritz" <twftesla-at-qwest-dot-net>
Hi All,
For the OLTC effort, I have to wind like a mile and a half of wire on a
secondary.
I went and got like $10 worth of stuff for this;
http://hot-streamer-dot-com/temp/OLTC08-22-04.jpg
http://hot-streamer-dot-com/temp/OLTC08-22-05.jpg
http://hot-streamer-dot-com/temp/OLTC08-22-05.jpg
Seems to test out fine. The drill easily stops if the torque incresses so
no borken wires. The variac controls the speed of the drill just fine. I
think this will work well.
Cheers,
Terry