Re: Primary radius inside secondary radius/ elevated secondary?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "rheidlebaugh by way of Terry Fritz <twftesla-at-qwest-dot-net>" <rheidlebaugh-at-zialink-dot-com>

Jolyon: I have one coil made that way and it works well.
   Robert  H

> From: "Tesla list" <tesla-at-pupman-dot-com>
> Date: Sun, 11 Aug 2002 10:34:30 -0600
> To: tesla-at-pupman-dot-com
> Subject: Primary radius inside secondary radius/ elevated secondary?
> Resent-From: tesla-at-pupman-dot-com
> Resent-Date: Sun, 11 Aug 2002 10:43:45 -0600
> 
> Original poster: "Jolyon Vater Cox by way of Terry Fritz
<twftesla-at-qwest-dot-net>"
> <jolyon-at-vatercox.freeserve.co.uk>
> 
> I intend to build a thirty-two turn primary with wires pitched 5/8" apart the
> width of my mounting board is too small to permit such an arragement with
a 3"
> secondary at the centre -allowing or not for the customary 1" spacing between
> primary and secondary.
> 
> My planned solution is to raise the secondary ABOVE the primary on insulated
> supports -so the primary radius will in effect be within the radius of the
> secondary. Is this OK?
> 
> 
> 
>